Ansys Assistant will be unavailable on the Learning Forum starting January 30. An upgraded version is coming soon. We apologize for any inconvenience and appreciate your patience. Stay tuned for updates.

Ansys Learning Forum › Forums › Discuss Simulation › General Mechanical › Simulation error › Reply To: Simulation error

November 21, 2023 at 5:56 pm
ErKo
Ansys Employee

 

 

Think make sure that this (apdl commands) is only active for step 1, as the 2nd step is cooling and thus this apdl command snippet (that adds a heat source), does not need to run in the 2nd step.

See here how to select steps for the commands (so set it to First).

/forum/forums/topic/step-selection-mode-for-apdl-command-in-workbench/

Erik

 

 

[bingo_chatbox]