We have an exciting announcement about badges coming in May 2025. Until then, we will temporarily stop issuing new badges for course completions and certifications. However, all completions will be recorded and fulfilled after May 2025.

Ansys Learning Forum › Forums › Discuss Simulation › General Mechanical › Issues with Simultaneous Meshing of Surfaces and Solid Model in ACP Pre and Mech › Reply To: Issues with Simultaneous Meshing of Surfaces and Solid Model in ACP Pre and Mech

November 3, 2023 at 7:13 pm
sadati
Subscriber

Hi, 

No, I didn't get any error or warning.

Yes, I built the composite layup on a surface and then mapped the layup on a solid model. I also tried on a simplified model, but It didn't work as well and It couldn't create the layup on a solid model. 

Sorry, I cannot open this link.