We’re putting the final touches on our new badges platform. Badge issuance remains temporarily paused, but all completions are being recorded and will be fulfilled once the platform is live. Thank you for your patience.

Ansys Learning Forum › Forums › Discuss Simulation › 3D Design › Creation of Periodic B.C in ICEM › Reply To: Creation of Periodic B.C in ICEM

November 2, 2023 at 5:06 am
Aras karimi
Subscriber

Dear mjmiddle,

For another case, I need to create a symmetry boundary condition between the front and back surfaces of the domain.That is, the front surface of  Symmetry1  and the back surface of Domain Symmetry2.

For this situation, do I not need to set the Global Mesh Setup? And only and only in the Part Boundary Conditions section, should I define two surfaces symmetrically?

 

I mean, in order to create a symmetric boundary condition, there is no need for special work like creating a periodic boundary condition?

 

Regards