We’re putting the final touches on our new badges platform. Badge issuance remains temporarily paused, but all completions are being recorded and will be fulfilled once the platform is live. Thank you for your patience.

Ansys Learning Forum › Forums › Discuss Simulation › General Mechanical › Ply type doubt. Composites. Engineering material › Reply To: Ply type doubt. Composites. Engineering material

October 27, 2023 at 6:54 am
Ravi Pant
Subscriber

Hi Everyone,

I am just starting on ANSYS ACP. Have some basic doubts:

  1. I have to analyse a composite with epoxy and jute fibre (6 strands) with the total thickness of 10 mm (2mm epoxy between fibre strands) - for this what thickness should i assign to the mesh...secondly while creating fabric in ACP pre which material to select and what should be the thickness...thirdly how to make stackup for this.
  2. Also i am a bit confused on specifying the thickness of the ply.

Please reply if anyone can help. Also if possible we can connect on teams.

 

Thanks & Regards,

Ravi Pant

ravipant@live.in

;: