We have an exciting announcement about badges coming in May 2025. Until then, we will temporarily stop issuing new badges for course completions and certifications. However, all completions will be recorded and fulfilled after May 2025.

Ansys Learning Forum Forums Discuss Simulation General Mechanical ACP: How can I run a postprocessing with two composite parts as one integrated part? Reply To: ACP: How can I run a postprocessing with two composite parts as one integrated part?

ariel.lusty
Subscriber

 

I had a similar problem and tried peteroznewman's solution but only one of the plies from each ACP setup show up in the solo Mechanical Model, creating an unwanted gap between the two parts. Does anyone know how to get all of the plies to show up when combining multiple parts?Â