We have an exciting announcement about badges coming in May 2025. Until then, we will temporarily stop issuing new badges for course completions and certifications. However, all completions will be recorded and fulfilled after May 2025.

Ansys Learning Forum › Forums › Discuss Simulation › Fluids › SOEC (Solid Oxide Electrolyser Cell) – Some questions in Simulations › Reply To: SOEC (Solid Oxide Electrolyser Cell) – Some questions in Simulations

September 27, 2023 at 5:21 pm
Raúl Sotillo
Subscriber

Hello Aleksey. Thanks so much for the answer. This solves a few months of doubts about this; in the guide, it was somehow explained but I couldn’t properly catch it. I also dropped a question on that topic here.

How can I set up the voltage from the PC&E Panel? I can only see how to set up the OCV, which in my case I’ve set up to +0.84V. And then I always indicate that on the Boundary Conditions.

Kind regards,
Raúl