We have an exciting announcement about badges coming in May 2025. Until then, we will temporarily stop issuing new badges for course completions and certifications. However, all completions will be recorded and fulfilled after May 2025.

Ansys Learning Forum › Forums › Discuss Simulation › Photonics › Meshing stops at 5% › Reply To: Meshing stops at 5%

September 27, 2023 at 1:11 pm
Dev
Ansys Employee

Thank you for confirming. 

I am glad to hear the issue is resolved. 

Another person who has a similar problem will find the content useful. That is one of the reasons there isn't a delete option. Thank you for using the forum, and please keep asking questions here. 
I am closing this post.

Regards

Devika