We have an exciting announcement about badges coming in May 2025. Until then, we will temporarily stop issuing new badges for course completions and certifications. However, all completions will be recorded and fulfilled after May 2025.

Ansys Learning Forum › Forums › Discuss Simulation › Electronics › How to check accuracy of the values? › Reply To: How to check accuracy of the values?

September 26, 2023 at 6:13 pm
HDLI
Ansys Employee

Hello Vedant,

       I think PI is not infinite number in Maxwell, so sine(180) or sin(PI) would be much smaller number to close 0. Because of this small value, we could consider it as zero and FEA results would be good enough. Thanks.

HDLI  

Â