We have an exciting announcement about badges coming in May 2025. Until then, we will temporarily stop issuing new badges for course completions and certifications. However, all completions will be recorded and fulfilled after May 2025.

Ansys Learning Forum › Forums › Discuss Simulation › Electronics › Replicating a section of cylinder with elements into full cylinder › Reply To: Replicating a section of cylinder with elements into full cylinder

August 1, 2023 at 4:32 am
SIDDHARTH MOHAN
Subscriber

thanks for the reply. Is there another way to complete this arc into a full cylinder ? The existing methods (drawing a circle and increasing it's thickness) that I have been trying are not working well. 

 

Edge of the arc :