We have an exciting announcement about badges coming in May 2025. Until then, we will temporarily stop issuing new badges for course completions and certifications. However, all completions will be recorded and fulfilled after May 2025.

Ansys Learning Forum › Forums › Discuss Simulation › General Mechanical › How create an initial condition for a transient anaysis › Reply To: How create an initial condition for a transient anaysis

July 18, 2023 at 1:41 pm
Ashish Khemka
Forum Moderator

Hi,

I cannot see the exact error. Can you try increasing the substeps or number of iterations? By default Mechanical uses 25/26 iterations. You can increase this value by issuing a command under setup branch. Use the command: neqit,50 (no. of equilibrium iterations =50).

Regards,

Ashish Khemka