We have an exciting announcement about badges coming in May 2025. Until then, we will temporarily stop issuing new badges for course completions and certifications. However, all completions will be recorded and fulfilled after May 2025.

Ansys Learning Forum › Forums › Discuss Simulation › Fluids › How to setup a stable sand layer by using Eulerian granular multiphase › Reply To: How to setup a stable sand layer by using Eulerian granular multiphase

July 3, 2023 at 11:17 am
Rob
Forum Moderator

Check the convergence on the steady model, chances are the solver is struggling and will then lose mass: remember the solution is the equilibrium state which means a 0.1% mass loss at inifinite time is nothing is left.

The transient model may also not be fully retaining the mass, but it's a slower process.Â