The Ansys Innovation Space website recently experienced a database corruption issue. While service has been restored there appears to have been some data loss from November 13. We are still investigating and apologize for any issues our users may have as a result.

Ansys Learning Forum › Forums › Discuss Simulation › General Mechanical › AM process with ealive and restart leads to sig$segv error › Reply To: AM process with ealive and restart leads to sig$segv error

February 22, 2023 at 5:31 pm
John Miller
Subscriber

 

 

Hello together,

I was able to get rid of the sig$segv error via removal of the thopt,full line.

 

! tintp,,,,1.0
!lnsrch,on
!nropt,full
!thopt,full

…

*do,i,1,k,1
/GOPR
rescontrol,define,2,k 

The command rescontrol is generating the necessary .rnnn file, but I’m not able to generate the .rdb file within the script. In thermal analysis “restart control” isn’t available via GUI (only in mechanical).

Below is the error message attached

Is there a way to perform a restart analysis in thermal transient (with script based .rdb file generation)?

Best regards

John