We have an exciting announcement about badges coming in May 2025. Until then, we will temporarily stop issuing new badges for course completions and certifications. However, all completions will be recorded and fulfilled after May 2025.

Ansys Learning Forum › Forums › Discuss Simulation › General Mechanical › Ansys OptiSlang Warning/Error › Reply To: Ansys OptiSlang Warning/Error

February 22, 2023 at 4:16 pm
hkanakri
Subscriber

Hi Erik,

I am planning to use IPM Flat simple machine. I noticed that the ratio mode is not available for this type of machine. 

What do you suggest to enable optislang for this type of machine?

Thanks,

HaithamÂ