We’re putting the final touches on our new badges platform. Badge issuance remains temporarily paused, but all completions are being recorded and will be fulfilled once the platform is live. Thank you for your patience.

Ansys Learning Forum › Forums › Discuss Simulation › Fluids › fluent setup method › Reply To: fluent setup method

September 22, 2022 at 2:48 pm
Luca Capitelli
Subscriber

I have a mesh with 232000 cells and 128500 nodes. I used edge sizing about 20 mm on the cylinder with growth rate 1,2. Then I used inflation with first layer thickness of 2 mm, 150 max layers and growth rate of 1. May I increase the cell number?