We have an exciting announcement about badges coming in May 2025. Until then, we will temporarily stop issuing new badges for course completions and certifications. However, all completions will be recorded and fulfilled after May 2025.

Ansys Learning Forum › Forums › Discuss Simulation › LS Dyna › Is it possible to use rough contact between belt and pulley to simulate timing belt? › Reply To: Is it possible to use rough contact between belt and pulley to simulate timing belt?

February 20, 2022 at 5:03 am
meldeeb
Subscriber
Thank you Ms. CXQUAN,
I have another question, for application like that, should I do explicit dynamics analysis or transient analysis?
Knowing that, I am simulating a full robot and I am caring about deformation at some parts??
I transient analysis is better, in this case, the idea of rough contact is good or not?