Ansys Learning Forum › Forums › Discuss Simulation › Fluids › Standard Initialization and Patching is not applying at the boundary › Reply To: Standard Initialization and Patching is not applying at the boundary
October 29, 2021 at 2:17 pm
gindi
Subscriber
I tried:
1) setting the initial volume fraction for water = 1, and patching air region as water volume fraction = 0.
2) setting the initial volume fraction for water = 0, and patching water region and pipe region as water volume fraction = 1.
Both ways gives the same result.
The odd thing is that I have a similar model but without the floor slope that doesn't have this issue. I tried reconstructing the geometry again as I though i might have missed something but still the same issue persists.
1) setting the initial volume fraction for water = 1, and patching air region as water volume fraction = 0.
2) setting the initial volume fraction for water = 0, and patching water region and pipe region as water volume fraction = 1.
Both ways gives the same result.
The odd thing is that I have a similar model but without the floor slope that doesn't have this issue. I tried reconstructing the geometry again as I though i might have missed something but still the same issue persists.
You are navigating away from the AIS Discovery experience