We have an exciting announcement about badges coming in May 2025. Until then, we will temporarily stop issuing new badges for course completions and certifications. However, all completions will be recorded and fulfilled after May 2025.

Ansys Learning Forum › Forums › Discuss Simulation › General Mechanical › How to make Absorbing Boundary condition in a 3D Soil -Structure model using Ansys202R1 › Reply To: How to make Absorbing Boundary condition in a 3D Soil -Structure model using Ansys202R1

October 29, 2021 at 6:25 am
mrigola
Subscriber
Dear Dlooman I have gone through the Ansys Element INFIN257 from Ansys Mechanical element ref doc and noted that I have to develop these elements as an additional layer over my soil elements(Solid 186 which is already modelled ).But I am not getting any reference of APDL command lines to do this job as the command lines to develop INFIN257 is required to be known for inserting the same.I will be grateful if you can throw some light.