We’re putting the final touches on our new badges platform. Badge issuance remains temporarily paused, but all completions are being recorded and will be fulfilled once the platform is live. Thank you for your patience.

Ansys Learning Forum › Forums › Discuss Simulation › Fluids › Error report in multiphase flow simulation › Reply To: Error report in multiphase flow simulation

October 26, 2021 at 3:59 pm
Rob
Forum Moderator
If you use Workbench Meshing or Fluent Meshing it's a few button clicks to remesh. Aim for an aspect ratio near around 1 next to the inlet and for the first few diameters plus at the bends. Patch in the near inlet cell to be the correct phase for the adjacent inlet too.