Ansys Learning Forum › Forums › Discuss Simulation › General Mechanical › How can I input time substeps manually in static structural? › Reply To: How can I input time substeps manually in static structural?

September 2, 2021 at 4:36 pm
Rameez_ul_Haq
Subscriber
,well, I want to observe the results at 1 sec and I want to have just one substep for each load step, so are these settings correct? I am choosing only 1 substep since I want the analysis to be conducted at only those timesteps which I have entered.
Number of Steps = 12, Current Step Number = 12, Step End Time = 1, Auto Time Stepping = OFF, Number of Substeps = 1.