We’re putting the final touches on our new badges platform. Badge issuance remains temporarily paused, but all completions are being recorded and will be fulfilled once the platform is live. Thank you for your patience.

Ansys Learning Forum › Forums › Discuss Simulation › General Mechanical › Not able to proceed with pre meshed crack › Reply To: Not able to proceed with pre meshed crack

July 25, 2021 at 4:11 pm
Amith_Anoop_Kumar
Subscriber
Thanks for the reply . But the problem is ansys 2D , so is there a method we can give solid elements to a 2D surface . Because this is a problem taken for verification manual of ansys hence there a surface itsel is used itsnt a 3d component so how to proceed