Ansys Learning Forum › Forums › Discuss Simulation › General Mechanical › 3 Point bending in MAPDL › Reply To: 3 Point bending in MAPDL
July 21, 2021 at 2:44 pm
Erik Kostson
Ansys Employee
Hi
We are not allowed to downloads that.
I would suggest to take some of our courses in ansys (they are free), and look into some apdl examples on the internet or our verification manual to get started (have in mind that padl can take some time to learn since it involves commands).
Best of luck
We are not allowed to downloads that.
I would suggest to take some of our courses in ansys (they are free), and look into some apdl examples on the internet or our verification manual to get started (have in mind that padl can take some time to learn since it involves commands).
Best of luck