We have an exciting announcement about badges coming in May 2025. Until then, we will temporarily stop issuing new badges for course completions and certifications. However, all completions will be recorded and fulfilled after May 2025.

Ansys Learning Forum › Forums › Discuss Simulation › Electronics › EM Loss Not Importing to Icepak in AEDT › Reply To: EM Loss Not Importing to Icepak in AEDT

January 12, 2021 at 3:01 pm
meiermat
Subscriber
The 1750? temperature is right. I put 500W into a 25mm diameter air-cooled loop, so obviously that's ludicrous. I just wanted to see if the solver was working. I'm using Icepak within AEDT, version 2020R2.nI feel like an idiot...I didn't even know there pre-built examples for the EM/Icepak link. Regardless, coil_plate.aedt doesn't work, either, and the behavior has changed over the past couple days so I'm pretty sure this is a problem with our installation at the university.nMattn