We’re putting the final touches on our new badges platform. Badge issuance remains temporarily paused, but all completions are being recorded and will be fulfilled once the platform is live. Thank you for your patience.

Ansys Learning Forum › Forums › Discuss Simulation › Electronics › Error: system matrix is badly conditioned.. 1% › Reply To: Error: system matrix is badly conditioned.. 1%

April 2, 2019 at 2:05 pm
Mark Solveson
Ansys Employee

Can you please check to see if the conductivity of the object is defined properly?  


Also, ensure that your excitation defined on the coil in Maxwell is setup in one of two ways: 
1.  The coil terminals extend to the solution region, where the excitations are assigned on the start and end of the conductor. 
2.  The coil terminals form a closed loop, where the excitation is assigned to a cross section. Â