Ansys Innovation Space

FREE STUDENT SOFTWARE

Setting for TPU

- April 20, 2021 at 7:10 am
  
  DavidJo23
  Subscriber
  
  Hi, what are people finding the best settings for printing TPU. At the moment I have the speed at 25mm as any higher the filament just sticks in the gears. The print is so slow it?s just silly. Is there a better way. The printer is an ender 3.n
- April 22, 2021 at 4:12 pm
  
  John Doyle
  Ansys Employee
  
  It sounds like you are asking about an actual 3D printing operation of a thermoplastic (TPU) on a Ender 3 machine. Is that correct? You are not trying to simulate this build in ANSYS right?nIf that is the case, you might want to reach out to the support folks for this particular machine. n
- April 23, 2021 at 4:17 am
  
  DavidJo23
  Subscriber
  
  Thanks! TPU is probably not the question of this forum.n

Viewing 2 reply threads

The topic ‘Setting for TPU’ is closed to new replies.

Ansys Assistant

Hey there, you are quite inquisitive!
You have hit your hourly question limit.
Please retry after '10' minutes.
For questions, please reach out to ansyslearn@ansys.com.

RETRY

Are you sure you want to leave? The window will be closed.

OK