Learning Forum

[siderite]

Hello everyone,

I am now working with Ansys ACP post-processing. As you can see in the picture below, I have combined two composite parts in the Static Structural Analysis system by assigning them a contact. 

The problem is that I want to show the postprocessing result of the combined part, not separately as in the picture where I marked it with yellow. 

Is there any way to show the postprocessing result of two parts at the same time?

[peteroznewman]

Like this?n

[ariel.lusty]

 

I had a similar problem and tried peteroznewman's solution but only one of the plies from each ACP setup show up in the solo Mechanical Model, creating an unwanted gap between the two parts. Does anyone know how to get all of the plies to show up when combining multiple parts?