How to enable viewing results on a beam?

- February 6, 2021 at 8:29 am
  
  elhamasadi
  Subscriber
  
  In modelling a stiffened plate, I can not capture the equivalent stresses on the beam. Here is the contour plot I get:
- February 6, 2021 at 12:41 pm
  
  ErKo
  Ansys Employee
  
  If you mean that you have beam elements for the lower part that are transparent in the image above, and that you can not see stresses there, go to the Solution (A6) ->under Beam section results set it to YES (see below).nHope this helpsnn
- February 6, 2021 at 12:42 pm
  
  peteroznewman
  Subscriber
  
  nInsert a Beam Tool into the Solution branch. Then you can plot stress components in the beam. Read Help on Beam Tool for more information. Open ANSYS Help, then copy paste the URL below into the address bar of the browser.nhttps://ansyshelp.ansys.com/account/secured?returnurl=/Views/Secured/corp/v211/en/wb_sim/ds_Beam_Tool.html?q=beam%20tooln
- February 7, 2021 at 1:38 pm
  
  elhamasadi
  Subscriber
  
  nThank you, I could overcome it.n