Learning Forum

[ninanikolic]

Hello,

While doing the modal and harmonic response analysis, I was getting the following error:

 

"An error occurred when the post processor attempted to load a specific load".  Also there shows some messages which are saying that the current file can not be open and result file may not contain requested data. I have attached the file for your convenience. What can I specifically do to solve the problem?

[Aniket Chavan]

Ansys staff can not download images or files on the student portal, so if you want to reach a larger audience to get answers from, please insert the images inline for the errors that you see.n-AniketnHow to access Ansys help linksnGuidelines for Posting on Ansys Learning Forumn

[ninanikolic]

THANKS FOR INFO!nIt is all ok until it solves, there is suficient space on disk, I don´t know what could be the cause this error?n

[Aniket Chavan]

Can you please go to solver output from solution information and check for the force converge and check for errors and paste the errors here?nThere is one setting in output setting under analysis data management in analysis settings, for outputing additional quantities, but it seems like you are not asking for something unusual that requires changes from defaults, did you change these settings?n-AniketnHow to access Ansys help linksnGuidelines for Posting on Ansys Learning Forumn

[ninanikolic]

The model in which i didnt used sweep works perfectly fine. I just wanted to increase number of elements throw the thikness of elements, maybe that is problem?nn

[Aniket Chavan]

You seem to use enterprise license, this would need some more debugging, may I suggest opening a new Service request if that is possible for you?n-AniketnHow to access Ansys help linksnGuidelines for Posting on Ansys Learning Forumn

[ninanikolic]

unfortunatelly,it?s not possible...Is there any other solution?n

[Aniket Chavan]

ninanikolic, May I ask the reason why it is not possible?nOne thing I can suggest is clear generated results, all the result objects along with messages and warnings in the message pane and try this again, and see if you see any error in the solver outuput?nIf not try to reset the appdata and do this again. Error in solver output file would be important to debug the issue any further.n-AniketnHow to access Ansys help linksnGuidelines for Posting on Ansys Learning Forumn