Error Message: The solver engine was unable to converge on a solution for the nonlinear problem as c

- September 22, 2020 at 10:59 am
  
  bibas
  Subscriber
  
  ArrayI am trying to simulate a deformation on a wing spar with two spars attached to it. A pressure is being applied on both spars.n Can anyone help me figure out what am i doing wrong?nBest regardsnBeatrizn
- September 23, 2020 at 5:30 pm
  
  SaiD
  Ansys Employee
  
  Hi,nDue to company policies, Ansys employees cannot download any attachments. Could you please insert some inline images showing your geometry, contacts (if any), the boundary conditions and loads you apply and the error messages you are getting?nThanks,nSain
- September 24, 2020 at 6:09 am
  
  MTBXC
  Subscriber
  
  The pressures introduced are having problems with convergence. Do you predict such a heavy load for sure? Maybe you made a mistake in units?n
- September 24, 2020 at 9:13 am
  
  bibas
  Subscriber
- September 24, 2020 at 9:18 am
  
  bibas
  Subscriber
  
  Should i put any other images?nI want to apply pressure in the two spars at the same time to see the deformation in the wing spar in the center that later will be inserted a fracture on, but it only runs one pressure at a time...n
- September 24, 2020 at 12:31 pm
  
  bibas
  Subscriber
  
  n
- September 24, 2020 at 1:05 pm
  
  SaiD
  Ansys Employee
  
  Hi,nWe noticed a duplicate post on the forum by you: /forum/discussion/20544/error-message-the-solver-engine-was-unable-to-converge-on-a-solution-for-the-nonlinear-problem-as-c#latestnSo we will be continuing the discussion on the post mentioned above.nIn future, please avoid duplicate posts to prevent confusion and make book keeping easier.nSain
- September 24, 2020 at 1:14 pm
  
  Karthik Remella
  Administrator
  
  Hello,nI'm going to be closing this post now to streamline support.nThanks.nKarthikn