run simulations in sequence????? [ansys maxwell]

- September 19, 2020 at 10:37 pm
  
  carolinat4
  Subscriber
  
  there is any way that i could run simulation in sequence? i have 9 files to run, each one takes about 1 hour to finish, i would like to know if there is a way to set up those simulations in sequence. i don't want to run all of them together because probably my pc will crash. i'm using ansys maxwell. thank you.n
- September 21, 2020 at 1:15 pm
  
  NKC
  Forum Moderator
  
  Hi,nTo run the simulations in sequence you can you use queue simulations settings as shown below.nnnRegardsnNavyan