TAGGED: coupling, maxwell-fluent, water, water-flow
-
-
September 18, 2020 at 11:08 am
sarathmail63
SubscriberI'm looking for simulating a water flow meter in Maxwell3D. It based on the principle of Faraday's Law of Electromagnetic Induction, according to which liquid generates voltage when it flows through a magnetic field. The voltage produced is directly proportional to the water movement. The voltage signal is processed into the volumetric flow rate by the electronics.ni would like to know how to apply water flow movement in simulation thus by calculating the pickup voltage through receiver wire.n
-
September 18, 2020 at 4:56 pm
Karthik Remella
AdministratorHello,nI'm answering this question here. Please use the following thread to respond.nI want to simulate a water flow meter/forum/discussion/20020/how-a-flow-is-aligned-in-maxwell
Thanks.nKarthikn
-
Viewing 1 reply thread
- The topic ‘How to give flow movement of water for coupling with Ansys maxwell’ is closed to new replies.
Ansys Innovation Space
Trending discussions
- air flow in and out of computer case
- Varying Bond model parameters to mimic soil particle cohesion/stiction
- Eroded Mass due to Erosion of Soil Particles by Fluids
- Guidance needed for Conjugate Heat Transfer Analysis for a 3s3p Li-ion Battery
- Centrifugal Fan Analysis for Determination of Characteristic Curve
- I am doing a corona simulation. But particles are not spreading.
- Issue to compile a UDF in ANSYS Fluent
- JACOBI Convergence Issue in ANSYS AQWA
- affinity not set
- Resuming SAG Mill Simulation with New Particle Batch in Rocky
Top Contributors
-
3862
-
1414
-
1236
-
1118
-
1015
Top Rated Tags
© 2025 Copyright ANSYS, Inc. All rights reserved.
Ansys does not support the usage of unauthorized Ansys software. Please visit www.ansys.com to obtain an official distribution.