Learning Forum

[1260960796]

In SpaceClaim, I create many points which are not coplanar. Now I need connect them by line(or spline), but only in "sketch" mode can I use "line" function. That means I only can connect two points in a plane. What's more, after connecting per two points I should alter another sketch plane. Why can't SpaceClaim offer a function that connect two spatial points directly?

I notice that "Design"→"Create" (Figure below) can creates points and planes, only lines can not be created, which annoys me a lot. That's why? ?

[peteroznewman]

On the Sketch tab, click the Enable 3D Sketch button so you can draw a line between points in 3D space. 

[1260960796]

Thanks a lot