Increasing font size of exported images + controlling resolution.

- June 9, 2020 at 1:49 pm
  
  faradai2008
  Subscriber
  
  Hello,
  
  I would like to know how to control the resolution of exported images + how to increase font size.
  
  I already used the exportation dialog as shown in the attached figure. The problem is that I cannot increase the font scaling factor beyond 1.5. When I do this, the exported image doesn't change and the scaling factor resets to 1.5.
  Also, is there a way to have consistent size/resolution for all exported images. I am including these images in Latex.
  
  Thanks in advance
  
  greetings
- June 9, 2020 at 2:55 pm
  
  Rob
  Forum Moderator
  
  I'm not sure what you're exporting from, but check you're setting an image size and not using the graphics window size.
- June 9, 2020 at 3:05 pm
  
  faradai2008
  Subscriber
  
  I'm exporting from ansys mechanical using the button shown in the following pic.
  How can I set an image size? I haven't seen such option anywhere!