Version change error

- June 3, 2020 at 4:30 pm
  
  mekafime
  Subscriber
  
  Hi,
  
  The ansys version was updated to 2020 R1 when I try to open the model, an error is indicated by the geometry apparently, but the solid from which the geometry is derived is fine, any suggestions? please
- June 4, 2020 at 5:43 am
  
  Aniket
  Forum Moderator
  
  open DM in system B and check if cross sections are assigned to line bodies there.
  
  -Aniket
  
  How to access Ansys Online Help Document
  
  How to show full resolution image
  
  Guidelines on the Student Community
  
  How to use Google to search within Ansys Student Community
- June 7, 2020 at 5:00 pm
  
  mekafime
  Subscriber
  
  Hi Aniket
  
  the section is correct ..
- June 11, 2020 at 6:30 pm
  
  Aniket
  Forum Moderator
  
  This is weird, Only thing I can suggest is to insert a new system and then assemble both A and B systems to that system and see if that makes any difference.
  
  -Aniket
  
  How to access Ansys Online Help Document
  
  How to show full resolution image
  
  Guidelines on the Student Community
  
  How to use Google to search within Ansys Student Community
- June 12, 2020 at 6:13 pm
  
  mekafime
  Subscriber
  
  Hi Aniket,
  
  I had to do that, redo the model and it is already running normally. I find the error curious because this way I updated the version of Ansys nothing happened.
  
  Thanks.