Porous Media

- May 20, 2020 at 12:27 am
  
  agnesm
  Subscriber
  
  Hello all,
  
  I designed a porous media in Solidworks and l calculated its porosity. So, l wanted to ask if it is possible to find the permeability of the designed porous media using ANSYS?
- May 20, 2020 at 1:53 pm
  
  Rob
  Forum Moderator
  
  If you can mesh and model the fluid bits only then yes. You'd then use the approach outlined in the porous media bit of the manual (Cell & Boundary Conditions, Fluent User's Guide) to figure out the permeability.