Learning Forum

[Hasan]

Don't know if this is the issue tab "Select Solution to Merge"

[vinaraya]

HI,

The progress of the simulation could be seen by clicking the below icon. A separate GUI will open and you could see the progress.

Additionally, once the Forte simulation starts, a Nominal folder will be created. You could also open the file "MONITOR" in a Notepad to see the simulation progress.

I hope this answers your query. If not, kindly provide a bit more details on your issue and a clearer picture.

Thanks & Regards.

[Hasan]

What do the three rows mean in above image? 

I did open FM , didn't progress after I put laptop to sleep even I have solution saved after every one crank angle. Selected update on solution tab but didn't pickup from previous saved crank angle, rather restarted altogether.

[Hasan]

I have tried manual saving arrangements as shown but still didn't start up last time I restarted after computer shutting down.

[vinaraya]

HI,

If you are looking for guidance on Forte restart. Please refer the following section 5.9.1 in Forte user guide (24R2 manual). Section number could change will different releases.

5.9.1. Restart Files and Processing

Each of these icon - mean different things. If you hover your mouse over them - it will give short details. FM is meant for monitoring runs, EN - opens ensight and PST-Opens CFDPost

Regards,

[Hasan]

Will try reading maybe a video link explanation can help, if there is one thanks.

 

Also clicked on the +: sign to open a tab for parameters but no tab opened. I am looking for a way in varying spray injection timing, see attached image.

[Hasan]

I have seen these saved restart files similar to what shown in the link you have sent but when I selected the ***.ftrst file and pressed the green start button in the Run Simulation tab, nothing happened. Should I select the ***.ftrst, then select "Save Solution & Restart": button?

[Hasan]

Selected this +++.ftrst file and applied it, nothing happened. Pressed the Save Solution and estart button but still no progress on FM window.

[Hasan]

Same again, closed screen and opened again, it says Running for ... (in left side) but no progress when you look at the FM window.

[vinaraya]

Hi Hasan,

Your snippets are very blurred. I would recommend you to share clear pictures so that i can guide you.

Have you gone through the section on Forte restart from User guide manual (link shared in an earlier response) ?

[Hasan]

Yes I have and what I understand is if you press the Save Solution & Restart while it's running then it will save (which it does). Then a few hours later when you switch on the laptop back, press the same button again and it should restart continuing from last save. This doesn't happen, most likely I missed something. Thanks.

[Hasan]

Not sure how to setup parameterization in Forte , please see attached image, got three different crank angle spray timings and it's running now but not sure if this is the right way.