Learning Forum

[javat33489]

Hello everyone. I need to calculate a large structure from different board sections. A total of 3000 elements. There are places where the boards penetrate each other due to a small offset, for example 0.1 - 0.5 mm. When calculating, such a bonded contact can give me an error. And some parts are too long and penetrate each other. The parts need to be shifted and trimmed, doing it manually takes a very long time.
Please tell me if it is possible to perform automatic fitting and trimming of parts in Space Claim?

[Akshay Singh]

Hello,

You can use the Interference Tool on the Prepare Tab of Spaceclaim to check for interfering geometries and take corrective action

More help can be found here: Interference Tool