Setting “Partial update” to “None” for calculating all design points at once

- April 1, 2020 at 1:34 pm
  
  HugoB
  Subscriber
  
  Hello everyone,
  
  First of all, I'm new on this forum so if my discussion is not in the right topic, just tell me where it's supposed to be posted and I will repost it there.
  
  I have a problem with calculating design points on my student version of ANSYS Workbench 2019 R3. When I'm defining multiple design points and changing the parameters for each one, I'm then updating all of them but I have a message telling me that the update is a "Partial update", which updates only geometry, and that I should set "Partial update" to "None" if I want Fluent to carry on the Configuration, Solution and Results calculations for each of my design points.
  
  The problem is that I couldn't find that option, even when looking on the Internet or in the ANSYS Fluent tutorial... Can somebody help me with that ?
  
  The only solution I found is to define one of my Design Point as the "current" one and then perform all the calculation, but if I have like 100 Design Points it will be very long to do it again each time...
  
  Tkank you in advance for your help, and pardon my bad english if I did some mistakes...
  
  Have a nice day !
- April 2, 2020 at 3:29 am
  
  Keyur Kanade
  Ansys Employee
  
  It is in help document.
  
  Please check
  
  https://ansyshelp.ansys.com/account/secured?returnurl=/Views/Secured/corp/v201/en/wb2_help/wb2h_partialdpupdates.html?q=Retaining%20Partial%20(Geometry-Only)%20Updates
  
  Regards,
  
  Keyur
  
  If this helps, please mark this post as 'Is Solution' to help others.
  
  Guidelines on the Student Community
  
  How to access ANSYS help links
- April 2, 2020 at 11:57 am
  
  HugoB
  Subscriber
  
  Thank you very much, this is exactly the document I needed !
  
  Have a nice day
- November 1, 2023 at 10:29 am
  
  Ashish Kumar
  Subscriber
  
  Hey, HugoB! Can you tell me where you find that option to revert the "partial update" to "none"? I am also unable to see it, and I don't know why I couldn't open the mentioned link. I appreciate any help you can provide.