ACP pre to static structural connection

- March 14, 2020 at 3:57 pm
  
  prernajangwal
  Subscriber
  
  Hi,
  
  I am not able to get the cell of 'section data' when I am dropping static structural onto ACP Pre. I tried it many times and through various ways but section data cell is not generated.
  
  If anyone could help me out with this, I would be really grateful.
- March 16, 2020 at 6:42 pm
  
  Aniket
  Forum Moderator
  
  connect ACP to static structural as shown in the image below, do not drop static structural system on ACP Pre system.
  
  To do this, first have ACP Pre set up. Then drag and drop the static structural system "near to" the ACP Pre system. Then connect the setup cell to Model cell.
  
  -Aniket
  
  Guidelines on the Student Community
  
  How to access ANSYS help links
- March 22, 2020 at 6:43 am
  
  prernajangwal
  Subscriber
  
  Thank you so much.
  
  Really appreciate your help.
- March 24, 2020 at 7:28 am
  
  Aniket
  Forum Moderator
  
  please mark the post as solution if it answered your question.