Additive Wizard not able to generate support

- February 12, 2020 at 6:35 pm
  
  ZengHuang
  Subscriber
  
  I am currently doing the Additive Manufacturing Process Simulation. The above image is my impeller at the MAPDL. As I am using the Additive Wizard, it should generate support automatically as I selected create support. But nothing has happen after that step.
  
  Unlike what I did to the single blade simulation, I have successfully generate the support with the same step.
  
  Can I know why this happen and how to solve this? Thank you!
- February 13, 2020 at 10:41 am
  
  Kajal Khan
  Ansys Employee
  
  Can you check it by changing the overhang angle in the wizard?
- February 16, 2020 at 2:50 pm
  
  ZengHuang
  Subscriber
  
  Yes, I have tested any value between 1 to 90 and it just doesn't work.