We’re putting the final touches on our new badges platform. Badge issuance remains temporarily paused, but all completions are being recorded and will be fulfilled once the platform is live. Thank you for your patience.

Ansys Learning Forum › Forums › Discuss Simulation › General Mechanical › ANSYS APDL – displacement constraints (D commands) in .CBDO file › Reply To: ANSYS APDL – displacement constraints (D commands) in .CBDO file

November 22, 2024 at 10:06 am
nils-erik.sanhen
Subscriber

Hello,

thank you for your reply.

In the modelling procedure I followed the manual. And I was able to create a solid-solid submodel. But in the follow up step, to create a shell-solid submodel, I was not able to generate a .CBDO consist out of an NMODIF block and and D block (dexcriped on page 148 of the document). My model consist soly on NMODIF commands. So I try to figure out what the cause of the problem is and how I can fix it.

If you have further ideas or examples I could take a look on, I would be happy.

Best greetings,

Nils Sanhen