We’re putting the final touches on our new badges platform. Badge issuance remains temporarily paused, but all completions are being recorded and will be fulfilled once the platform is live. Thank you for your patience.

Ansys Learning Forum › Forums › Discuss Simulation › Fluids › How do I create this type of Mesh › Reply To: How do I create this type of Mesh

November 15, 2024 at 1:03 pm
ae22b001
Subscriber

Hi so i tried to refine an existing mesh near the wall to reduce its ascept ratio. I wanted to split the cells into 2 to reduce its aspect ratio. To do that i set the minimum edge length to a value that is greater than the height of the cell. I expected it to only be refined in the other direction. However, it still splits the cell into 4, retaining its Aspect ratio. I split the zone into 2, to see a comparison of before vs after. 
How do I get it to split into 2 cells and not 4? Is that possible?