We’re putting the final touches on our new badges platform. Badge issuance remains temporarily paused, but all completions are being recorded and will be fulfilled once the platform is live. Thank you for your patience.

Ansys Learning Forum › Forums › Discuss Simulation › General Mechanical › How to set the relevant boundary conditions? › Reply To: How to set the relevant boundary conditions?

November 7, 2024 at 12:24 pm
Erik Kostson
Ansys Employee

Hi

It is a tricky one.

So as we said use frictionless support on A and B.

For the force it should be in neg., so - y direction (not pos.) .

Also it should be -5000 N (so half the force) since we use 1/2 symmetry :) - this is the tricky part.

With that we get the correct results.

All the best

 

Erik