We’re putting the final touches on our new badges platform. Badge issuance remains temporarily paused, but all completions are being recorded and will be fulfilled once the platform is live. Thank you for your patience.

Ansys Learning Forum › Forums › Discuss Simulation › Electronics › Simulation of Cascaded Resistors and Voltage Drops › Reply To: Simulation of Cascaded Resistors and Voltage Drops

November 7, 2024 at 11:15 am
Mrinmoy Bharadwaj
Ansys Employee

Kindly correct the set-up for correct results.
1. Your voltage source must be connected between VCC and GND (not NetR1_2). Both voltage and current source should have the same reference net.

2. Select the "negative" for the voltage source under "Node to ground".