We’re putting the final touches on our new badges platform. Badge issuance remains temporarily paused, but all completions are being recorded and will be fulfilled once the platform is live. Thank you for your patience.

Ansys Learning Forum › Forums › Discuss Simulation › General Mechanical › Calculation to the end with errors › Reply To: Calculation to the end with errors

November 4, 2024 at 10:47 am
Harshvardhan
Ansys Employee

Hi,
The NCNV, 1 command is for "Terminate the analysis and the program execution if the solution fails to converge (default)".
If you wish for the calculations to continue, try NCNV, 0.

More information can be found here: NCNV

I hope this helps.

Regards,
Harshvardhan
Ansys Help
Ansys Learning Forum (Rules & Guidelines)