Learning Forum

[javat33489]

Hello everyone.
Sometimes, when I calculate rubber, convergence is not important to me, but it is important to see how the product is deformed and where the main stresses are.
How can I make the calculation continue to the end despite errors and non-convergence?
I tried to use the NCNV,1 command, but it did not help.

[Harshvardhan]

Hi,
The NCNV, 1 command is for "Terminate the analysis and the program execution if the solution fails to converge (default)".
If you wish for the calculations to continue, try NCNV, 0.

More information can be found here: NCNV

I hope this helps.

Regards,
Harshvardhan
Ansys Help
Ansys Learning Forum (Rules & Guidelines)