Reply To: How to get the rotations of each node in a plate modeled through solid elements?

[Mehdi Baghaee]

 

I used *VGET command ( *VGET,RYt(1),NODE,1,ROT,Y ) to obtain ROTY of nodes, but as I said before, the *VGET command does not work and faced an error as below:

/BATCH  
/input,menust,tmp,''
WPSTYLE,,,,,,,,0
/NOPR   
KEYW,PR_SET,1   
KEYW,PR_STRUC,1 
KEYW,PR_THERM,0 
KEYW,PR_FLUID,0 
KEYW,PR_ELMAG,0 
KEYW,MAGNOD,0   
KEYW,MAGEDG,0   
KEYW,MAGHFE,0   
KEYW,MAGELC,0   
KEYW,PR_MULTI,0 
/GO 
/PREP7  
ET,1,SOLID185   
MPTEMP,,,,,,,,  
MPTEMP,1,0  
MPDATA,EX,1,,1e9
MPDATA,PRXY,1,,.3   
MPTEMP,,,,,,,,  
MPTEMP,1,0  
MPDATA,DENS,1,,6700 
BLOCK,0,10,0,10,0,1,
FLST,5,8,4,ORDE,2   
FITEM,5,1   
FITEM,5,-8  
CM,_Y,LINE  
LSEL, , , ,P51X 
CM,_Y1,LINE 
CMSEL,,_Y   
LESIZE,_Y1, , ,10, , , , ,1 
MSHAPE,0,3D 
MSHKEY,1
CM,_Y,VOLU  
VSEL, , , ,       1 
CM,_Y1,VOLU 
CHKMSH,'VOLU'   
CMSEL,S,_Y  
VMESH,_Y1   
CMDELE,_Y   
CMDELE,_Y1  
CMDELE,_Y2  
*dim,impulse,table,3
*SET,impulse(1,1),1,0       ,  0              ! VALUES OF EXCITATION
*SET,impulse(1,0),0,22*timestup,  1 ! CORRESPONDING VALUES OF TIME  
F, 177, FZ, %impulse%   
WPSTYLE,,,,,,,,0
FLST,2,44,1,ORDE,12 
FITEM,2,1   
FITEM,2,-11 
FITEM,2,122 
FITEM,2,143 
FITEM,2,153 
FITEM,2,-161
FITEM,2,243 
FITEM,2,-244
FITEM,2,267 
FITEM,2,-268
FITEM,2,287 
FITEM,2,-304
/GO 
D,P51X,ALL, , , , , , , , , ,   
ANTYPE,4
TRNOPT,FULL 
LUMPM,0 
FINISH  
/SOL
NSUBST,1000,0.01,0.001  
OUTRES,ERASE
OUTRES,ALL,ALL  
TIME,1  
SOLVE   
*GET, ARA,NODE,11,ROT,Y 

 ROTY is not a valid degree of freedom for this solution.  The DOF command may be used to add degrees of freedom.  

Any other suggestion?