Parameter calculation has stalled and there is no stop button to escape.

- November 24, 2019 at 11:57 am
  
  viranmistry08
  Subscriber
  
  I am trying to get results for different angle of attacks for an airfoil with a spinning cylinder in the leading edge. My mesh worked fine (y+<1) and the first 3 values worked, but it has now stopped. Is there any way to stop the calculation and how can it be prevented from happening again? Please can someone help me.
- November 25, 2019 at 11:30 am
  
  Rob
  Forum Moderator
  
  Check disc space: the other design points may not have completed cleanly either.
- November 25, 2019 at 9:06 pm
  
  peteroznewman
  Subscriber
  
  The complaint is that the red Stop button is missing from the right side of the Progress bar in the image above.
- November 26, 2019 at 12:05 am
  
  viranmistry08
  Subscriber
  
  Yes that is the problem. My test is to run an airfoil at different angles of attack. I have manged to do this for the conventional wing, and there is a stop button as you have shown, but for the unconventional wing with a spinning cylinder as the leading edge of the airfoil, i can only get a few values before it stops. My y+ value is below 1 for both configurations. I am not sure where I am going wrong.