We have an exciting announcement about badges coming in May 2025. Until then, we will temporarily stop issuing new badges for course completions and certifications. However, all completions will be recorded and fulfilled after May 2025.

Ansys Learning Forum › Forums › Discuss Simulation › Photonics › INTERCONNECT – No results unless rerun simulation until it gives any › Reply To: INTERCONNECT – No results unless rerun simulation until it gives any

October 23, 2024 at 11:05 am
sicli21
Subscriber

Hi, I uploaded another image. Parameters cannot be wrong because when I re-run my simulation I get expected results. But it can be several reruns to get the result. I observe this effect whenever I use OMM. In the image below blue and green are from same simulation but different runs. 

Â