Operation would result in non-manifold bodies

- October 5, 2024 at 2:08 pm
  
  titouan.reynaud1105
  Subscriber
  
  Hello everyone,
  I am new to the software, I am trying to set up a simulation for my FSAE race car, but when I want to create an enclosure, an error concerning non-manifold bodies occurs.
  But i have checked and my body is full (not hollow), and when I use the Too-Analysis fault for bodies nothing happens..
  Can someone help me out ?
  Thank you
- October 7, 2024 at 11:00 am
  
  Rob
  Forum Moderator
  
  Non-manifold tends to trigger when you have surface-surface contact with zero area. As an example where a cylinder contacts a flat surface: eg the bottom of the tyre. If you flatten the bottom of the tyre a bit (highly precise engineering dimension unit) does that help?