We have an exciting announcement about badges coming in May 2025. Until then, we will temporarily stop issuing new badges for course completions and certifications. However, all completions will be recorded and fulfilled after May 2025.
3D Design

3D Design

Topics related to Ansys Discovery and Ansys SpaceClaim.
  1. All Channels
  2. 3D Design
  3. Help Needed In Creating Inlet on Curved Surfaces

Help Needed In Creating Inlet on Curved Surfaces

TAGGED: ,

    • October 3, 2024 at 7:11 pm
      13120029
      Subscriber

      Hey, I am currently trying to simulate a combustion chamber using ANSYS. However, while creating the model in ANSYS SpaceClaim, I encountered a problem. I am trying to create inlet holes on the surface of a cylinder. Can anyone help me with how to create these inlet holes?

      Attached is a picture of what I am trying to create. The one circled in red is an example of the inlet hole I am trying to make. Thanks!

       

    • October 4, 2024 at 7:57 am
      Devendra Badgujar
      Forum Moderator

      Hello, 

      Once you sketch the circles on the curved surface, you will have to use the pull tool to create a cut and create a hole. Refer this Discovery SpaceClaim: Getting Started Tutorials - Pull Basics - Ansys Knowledge

      FYI, Discovery SpaceClaim: Tutorials - Ansys Knowledge

      Regards,

      Devendra 

Viewing 1 reply thread
  • You must be logged in to reply to this topic.
Ansys Innovation Space

© 2025 Copyright ANSYS, Inc. All rights reserved.

Ansys does not support the usage of unauthorized Ansys software. Please visit www.ansys.com to obtain an official distribution.